Skip to content

Analyser

The screen in the middle of the panel compares what goes into Preamble with what the preamp makes of it, band by band, while you play. It's also a touch pad for Lo cut and Hi cut: drag on it to place both cuts at once and watch what they take away.

LevelLoudQuiet
Preamble analyser Preamble analyser
20 HzFrequency20 kHz

Reading the screen

  • Across: frequency, from 20 Hz at the left to 20 kHz at the right. Slightly brighter columns of dots mark 100 Hz, 1 kHz and 10 kHz, which are labelled under the screen.
  • Up: level. Each row of dots is 2.5 dB. The screen tilts up by 4.5 dB per octave around 1 kHz, as many analysers do, so a typical mix reads closer to level instead of falling away toward the highs.
  • White dots: the dry path, which is the input as it arrives, before Input, with both channels mixed to mono.
  • Red dots: the wet path, after the preamp, Lo cut, Hi cut and Auto gain but before Mix. The red deepens toward the top of the screen, where the wet path is loudest.
  • The line: Lo cut and Hi cut together. It runs flat near the top while both are off and bends down where a cut takes away the lows or the highs.

Mix dims the side you hear less of. At 100% only the wet path plays, so the white fades back; at 0% the red fades instead. Levels jump up quickly and fall back slowly, so short peaks stay on screen long enough to read.

What it's for

  • Seeing what the drive adds. With Auto gain on, the wet path is level-matched to the input, so white and red sit close together wherever the preamp leaves the tone alone. Where red climbs above white as you push Input, the preamp is adding harmonics; where it drops below, the preamp or a cut is taking something away.
  • Trimming fizz and mud. When the red spreads well past the white at the top of the range, or piles up at the bottom, bring in Hi cut or Lo cut until the line trims it back.
  • Focusing the drive on a band. Narrow the band to turn the wet path into a band of saturation, such as a thin, mid-forward tone, then lower Mix to blend it under the full-range dry signal. The cuts work on the wet path only, so the dry side keeps its lows and highs.

Using it as a touch pad

Drag anywhere on the screen to move Lo cut and Hi cut together. Both knobs follow, and show their cutoffs under them while you drag.

Drag Effect
Left or right Slides the band down or up in frequency, keeping its width. The band travels as far along the frequency scale as the pointer does.
Up Narrows the band: the two cutoffs move toward each other until they meet.
Down Widens the band. All the way down turns both cuts off.
  • The pad moves the cuts from wherever they are. Clicking changes nothing, and nothing moves until you've dragged a few pixels.
  • With both cuts off, dragging up brings them in from either end, closing on the middle of the range at about 630 Hz.
  • Each cut stops at the end of its range: Lo cut at 5 kHz, Hi cut at 200 Hz.
  • Auto gain matches the level before the cuts, so a narrow band plays quieter than a wide one. Use Output to make up the difference.
  • The pad sets the same Lo cut and Hi cut parameters as the knobs, so your host records a drag as automation.
  • On iPhone and iPad, drag with one finger.