Time¶
The Time section sets delay length and stereo behaviour. Times can be expressed in milliseconds or synced to the host tempo (note, dotted, or triplet divisions).
Controls¶
| # | Control | Description |
|---|---|---|
| 1 | Time mode (L) | Click to cycle the left delay between ms, note, dotted, or triplet. |
| 2 | Link | Lock left and right delay times together. |
| 3 | Time mode (R) | Click to cycle the right delay between ms, note, dotted, or triplet. |
| 4 | Delay Time (L) | Left delay time in ms or synced note value. |
| 5 | Width | Stereo width of the delayed signal. |
| 6 | Delay Time (R) | Right delay time in ms or synced note value. |
| 7 | Pedal mode | Limit delay range to the active character profile, otherwise max 1200ms. |
Time units¶
| Unit | Meaning |
|---|---|
| Ms | Free delay time in milliseconds. |
| Note | Tempo-synced quarter-note divisions. |
| Dot | Dotted note divisions. |
| Trip | Triplet note divisions. |
In Note, Dot, or Trip, the equivalent delay in milliseconds is shown at the top of the delay knob; the value under the knob stays the note name.
Tips¶
- Enable Link to keep left and right times matched while adjusting one knob.
- The top ms value updates with tempo and knob position; click it to switch that channel back to Ms.
- Pedal mode clamps the delay range to the maximum defined by the active character profile. This results in behavior that is as close as possible to an original analog delay pedal.
- Maximum delay time depends on the selected tone profile (from 300 ms to 1200 ms).